Pillow industrial automatic sealing machine

NegotiableUpdate on 01/17

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

The industrial automatic sealing machine for pillows is controlled by a high-precision electronic time controller, regulated by a high-power transformer, and has the characteristics of rapid heating, which is highly welcomed by users.

Product Details

　　Pillow industrial automatic sealing machineOperation steps:

1. Connect power: Turn on the power selection switch as needed, and the power indicator light will turn on The power selection switch points to vacuum for vacuum sealing and points to vacuum inflation for vacuum inflation sealing.

2. Place the plastic bag containing the items inside the vacuum chamber, with the bag opening neatly placed on the heat seal (if used for inflatable packaging, at least one nozzle should be inserted into the bag opening).

3. Press down the hood,Vacuum pillow packaging machineThe vacuum indicator light on the panel lights up, and the vacuum pump starts pumping. The hood is automatically sucked in, and the vacuum knob can adjust the vacuum level according to packaging requirements. When adjusting, the amplitude should be small depending on the scale from low to high.

4. When the pumping reaches the set time (i.e. the required vacuum degree), the pumping ends, the pumping indicator light goes out, and the inflation indicator light lights up to indicate the start of inflation. The inflation knob can adjust the length of inflation time (i.e. the amount of inflation), using the same method as above; If inflation is not required, turn the power switch to the vacuum position, the program will automatically enter the vacuum packaging, and the inflation indicator light will turn off

　　Pillow industrial automatic sealing machineinstall：

1. The heat shrink packaging machine, like the winding machine, consumes a lot of power, so the input power must be greater than the nominal power on the shrink machine, otherwise it is easy to burn out the circuit or electrical components.

2. Like a packaging machine, the machine must be reliably grounded to protect personal safety.

3. Each machine is equipped with a power cable when it leaves the factory, and the end lead part has the identification symbol of the power supply. It must be connected correctly, and unauthorized operation may result in electric shock.

4. When the machine specifies a three-phase 380V power supply, the neutral wire must be input at the same time, which is similar to other packaging equipment in the standard three-phase four wire system, such as vacuum packaging machines. Otherwise, the machine cannot function properly and is prone to burning out internal electrical components.

5. The machine must be installed horizontally, otherwise it will shorten the service life of the electric heating tube. For machines with conveyor belts, their inclined installation will cause the conveyor belt to deviate from the center.

6. When the machine is used continuously for more than three months, the temperature resistant wires in the contraction chamber should be inspected and replaced according to their degree of aging.

7. When the machine is working, the operator's palms and other parts are not allowed to come into contact with the operating parts of the machine, especially the temperature inside the contraction chamber, which can easily cause burns.

8. After the packaging work is completed, the heating switch should be turned off first, and the conveyor motor and fan motor should continue to run for about 10 minutes before cutting off the entire power supply.

Operation steps: