Precision exhaust injection molding equipment

NegotiableUpdate on 01/17

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

The precision exhaust injection molding equipment is equipped with four major systems for exhaust and dehumidification, namely the barrel (material barrel), screw, feeding device, and control panel.

Product Details

　　Precision exhaust injection molding equipmentadvantage

1. No need to pre dry the water absorbing molding material, reducing the number of processes and saving time;

2. It can remove volatile substances to a minimum, improve the mechanical properties of the product, and enhance the appearance quality;

3. Improve the molding range, increase the product qualification rate, and make the process more stable.

4. Avoiding some material storage waste (such as occupying space, idle resources, and reducing capital turnover risks)

5. Improve product switching efficiency, changeover time, and waiting time;

6. Improve the utilization rate of factory layout and increase the rational utilization rate of equipment;

7. Using an injection molding machine dehumidification system can reduce the cost of injection molded products and significantly enhance the competitiveness of the enterprise

　　Precision exhaust injection molding equipmentNotes:

(1) Check if there is water or oil entering the electrical control box. If the electrical appliance is damp, do not turn it on. Electrical components should be dried by maintenance personnel before turning on the machine.

(2) Check if the power supply voltage meets the requirements, generally not exceeding ± 15%.

(3) Check if the emergency stop switch and front and rear safety door switches are functioning properly. Verify whether the rotation direction of the electric motor and oil pump is consistent.

(4) Check whether each cooling pipeline is unobstructed, and introduce cooling water into the cooling water jacket at the end of the oil cooler and the barrel.

(5) Check whether there is lubricating oil (grease) in each moving part and add sufficient lubricating oil.

(6) Turn on the electric heater and heat up each section of the barrel. When the temperature of each section reaches the required level, keep it warm for a period of time to stabilize the machine temperature. The insulation time varies depending on the requirements of different equipment and plastic materials.

(7) Add enough plastic into the hopper. According to the requirements of different plastics for injection molding, some raw materials need to be dried first.

(8) Cover the heat shield on the barrel to save energy and extend the lifespan of the electric heating coil and current contactor.