Fully automatic small crusher

NegotiableUpdate on 01/12

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

The fully automatic small crusher is suitable for crushing and reusing various reverse materials, especially for various types of hard plastics (such as material heads, shoe lasts, etc.), with better results.

Product Details

　　Fully automatic small crusherFeatures:

1. Front and rear soundproofing design, with minimal noise.

2. Simplified design, minimal footprint, and easy maintenance.

3. The door type separation design makes it easy to clean and replace the mesh.

The motor is equipped with overload protection and power chain lock protection to ensure mechanical and personal safety.

The manufacturing process is mature, and the body, tool holder, and other components are processed as a whole to ensure component accuracy.

Crush rubber heads and films, with special crushers available to meet different needs

　　maintenance

1. Mechanical equipment should be placed in a ventilated position to ensure the dissipation of heat during motor operation and extend its lifespan

2. Regularly check the screws of the knife. After using the new machine for 1 hour, use tools to tighten the screws of the moving and fixed knives, and strengthen the fixation between the blade and the knife holder

3. Lubricating oil should be regularly added to the bearings to ensure lubrication between them

4. To ensure the sharpness of the cutting edge, the knife should be checked regularly to ensure its sharpness and reduce unnecessary damage to other components caused by blunt or missing blades

5. Before the second start-up, the remaining debris in the machine room should be cleared to reduce start-up resistance The inertia cover and pulley cover should be opened regularly to remove the ash outlet under the flange, as the powder discharged from the crusher chamber enters the shaft bearing

6. When replacing the knife, the gap between the moving knife and the fixed knife should be 0.8mm for crushers with a power of 20hp or more, and 0.5mm for crushers with a power of 20hp or less The thinner the recycled material, the larger the gap can be adjusted appropriately

7. Regularly check whether the belt is loose and tighten it in a timely manner

8. The machine should be well grounded

　　Fully automatic small crusher # FormatStrongID_3#

1. After the user starts the machine, they should maintain its high speed for 2 ^ 3 minutes. If there are no abnormal conditions, they can then start the feeding process.

2. At work, pay attention to the operation status of the plastic crusher anytime and anywhere. Firstly, the feeding should be balanced to prevent blockage of the edge material room; Secondly, there is no need to work under long-term overload. If vibration, noise, high temperature of rolling bearings and myocardial cells, or spraying of materials are found, the machine should be turned off for inspection first, and the fault detection side can be used again.

Before starting the machine, manually rotate the motor rotor to check if the teeth, hammer blades, and motor rotor are running smoothly and reliably, if there are any impact problems in the crushing room, if the rotation direction of the motor rotor is consistent with the specific direction of the machine head, and if the lubrication of the power machine and products is excellent.

4. There is no need to randomly replace the belt pulley to prevent the crushing chamber from bursting due to too high a speed ratio, or to prevent the crusher from compromising its working efficiency due to too low a speed ratio.