Wholesale of 100 cubic meter three connected trial formwork for Hebei concrete

Hebei concrete flexural test mold manufacturerIntroduction:

Concrete flexural test mold

A mold used to make test specimens for testing the mechanical properties, long-term durability, and durability of concrete and mortar.

Structural characteristics:

The main components include the bottom template, side template partition shaft, bracket joint bolts, and butterfly nuts (as shown in the attached figure). The bottom template is made of high-strength cast iron and supplied by Hebei Dahong Experimental Instrument Co., Ltd. The side template and partition are supported by relatively hard carbon steel, and the bracket is fixed on the low template. The joint bolts are connected to the bracket with cylindrical pins and can rotate around the axis of the cylindrical pins.

Technical parameters

The planes that make up the mold cavity should be polished, and their unevenness should not exceed 0.05mm.

2. The non perpendicularity between the pressure bearing surface and adjacent surfaces should not exceed ± 0.5 degrees.

3. Internal dimensions of the model.

Trial mold size (mm) Side length (mm) 150 × 150 × 550

Hebei concrete flexural test mold manufacturerNotes:

1. During assembly, first place the two side templates perpendicular to each other on the bottom template plane, insert the shaft fitted on the joint bolt into the grooves at both ends of the side template, and fix it slightly.

2. Then insert the partition into the groove of the side template, align the two side templates, ensure that the mold cavity is square, and tighten the butterfly nut on the shaft while lightly tapping the supplier Hebei Dahong Experimental Instrument Co., Ltd. on the upper side of each plate with a wooden hammer to make its lower side on the same plane.

3. Then tighten the butterfly nut on the joint bolt to ensure that the lower side of each plate is close to the low template plane.

Verification method for concrete flexural test mold

1. Verify the newly purchased trial mold according to the following method.

1.1 Use a steel tape measure and a feeler gauge to select two different parts in two perpendicular directions of each model to measure the unevenness of the internal surface of the model, and take the arithmetic mean accurate to 0.01mm.

1.2 Use an angle ruler to measure the non perpendicularity of adjacent surfaces inside various models. Select different parts of each adjacent surface to measure two points, and take the arithmetic mean: accurate to 0.1 degrees.

1.3 Use a vernier caliper to measure the internal dimensions of various models, select two measuring points in each direction, and take the arithmetic mean: accurate to 0.1mm.

1.4 In use trial mold inspection, visually observe whether the test mold has obvious deformation and whether the combination is tightly attached.

Price commitment for concrete flexural test mold products:

1. In order to ensure the high reliability and good quality of the product, the selection of materials for the system is made from domestic or high-quality products.

2. Under the same competitive conditions, our supplier Hebei Dahong Experimental Instrument Co., Ltd. sincerely offers you a discounted price without compromising product technical performance or changing product components.

Promise of delivery time for concrete flexural test mold:

1. Product delivery time: Try to meet user requirements as much as possible. If there are special requirements that need to be completed in advance, our company can organize special production and installation to strive to meet user needs.

2. When delivering the product, our company provides the following documents to the user.

① Technical Maintenance and Repair Manual

② Outsourced parts manual and manufacturer

③ Provide a list of vulnerable parts and spare parts, and attach a certain amount of spare parts