Production of Chengdu Three line Speed Sensor

NegotiableUpdate on 01/17

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

The XS12JK-3P/Y three wire speed sensor is an electromagnetic sensor that outputs voltage by cutting magnetic field lines with a moving coil. Therefore, it does not require a power supply during operation. The sensor has the advantages of small size, sturdy and reliable, long service life, and does not require power or lubricating oil. It can be used with general secondary instruments. The shell is made of stainless steel, with strong output signal, good anti-interference performance, easy installation and use, and can be used in harsh environments such as smoke, oil and gas, water and gas.. It is an electromagnetic sensor that outputs voltage by cutting magnetic field lines with a moving coil, and therefore has the characteristics of not requiring power supply during operation and easy installation.

Product Details

XS12JK-3P/Y Three Wire Speed Sensor Product Overview:

This sensor has the advantages of small size, sturdy and reliable, long service life, no need for power supply and lubricating oil, and can be used with general secondary instruments. The shell is made of stainless steel, with strong output signal, good anti-interference performance, easy installation and use, and can be used in harsh environments such as smoke, oil and gas, water and gas.

Due to the use of new American technology and special materials, the sensitivity of the sensor has been greatly improved, and the sensor can be matched with the SZC series intelligent tachometer.

The sensor housing is made of M16 × 1 stainless steel tube, and the front end is made of pure iron with a diameter of 3.5. It is equipped with coils and encapsulated with epoxy resin. The sensor lead wire adopts X12K4P aviation plug, and its socket part is enclosed with stainless steel threaded tube after rounding, and the four terminals are connected, so the plug lead wire can be connected to any adjacent two ends.

Output voltage: (Measurement conditions: transmission gear 60 teeth, transmission gear material A3 steel, modulus 2, sensor end face distance from tooth tip less than 1mm). Due to installation conditions, materials, etc., the following table is for reference only. Speed: rpm 10 20 50 100 200 500 1000 2000 5000

Output voltage (effective value) ≥ 50mv 100mv 250mv 500mv 1v 2.5v 5v 8v 10v Output voltage waveform: involute gear - approximate sine wave, if the gear is slightly eccentric, it is an amplitude modulated sine wave; Orifice plates, square teeth, etc. - positive and negative pulses.

Gear material: The gear is made of metal material with strong magnetic permeability

Tooth profile: Forming an involute tooth profile is a suitable tooth profile. Using large modulus gears or other tooth profiles will result in significant waveform distortion, which will hinder accurate measurements. During installation, it should be noted that the center of the magnetic pole should be located at the center of the gear.

三线制转速传感器结构图

Technical parameters of three wire speed sensor:

01. Measurement range: 0-10KHz

02. Working power supply: DC12V (10-18V)

03. Output voltage: High level: approximate power supply; Low level: ≤ 0.7V

04. Gear material: Steel or other magnetic materials

05. Gear thickness: ≥ 8mm

06. Installation thread: M16 × 1 or other specifications

07. Operating temperature: -10~70 ℃ (ordinary wire), -10~85 ℃ (high temperature wire)

08. Output waveform: Square wave

09. Output mode: PNP output

10. Installation gap: 0.5-2mm

11. Protection method: reverse polarity, short circuit