Plastic granulation automatic production equipment

NegotiableUpdate on 01/12

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

Plastic granulation automatic production equipment is suitable for granulation processing of hard PVC, soft PVC, and PVC waste material recycling. The granulation process is easy to operate, with good drying effect and high degree of automation

Product Details

Plastic granulation automatic production equipmentStructural features:

(1) The screw is driven to rotate by a hydraulic system, and there is no relative motion between the screw and the barrel; Adjustable screw speed;

(2) The inner wall of the material cylinder is lined with wear-resistant materials; The material cylinder is equipped with a spiral plate (or a translational plate); The spiral plate continuously throws the material into the air and then falls back into the material cylinder, where it is stirred and kneaded by the screw to form granular material;

(3) The discharge form is either the powder outlet under the pneumatic valve or the manually shoveled powder outlet (depending on different models).

Precautions for using plastic granulation automatic production equipment:

1. The plastic granulator should operate in a forward direction; Avoid reversing.

2. The granulator should not be operated on an empty stomach while cooling. It must be operated on a hot machine for feeding to avoid sticking to the shaft.

3. It is strictly prohibited for iron or other debris to enter the feed inlet and vent hole of the granulator. To avoid accidents and affect production.

4. Always pay attention to changes in the body temperature, and when touching the strip with clean hands without touching them, immediately raise the temperature. Until the strip touches the hand, it is normal.

5. When the bearing part of the reducer burns or is accompanied by noise, it should be repaired in a timely manner and refilled with oil.

6. When the bearing parts at both ends of the host bearing chamber become hot or make noise, the machine should be stopped for maintenance and butter should be added. During normal operation, grease should be added to the bearing chamber every 5-6 days.

7. Pay attention to understanding the operating rules of the machine; For example, the temperature and speed of the machine can be dealt with in a timely manner according to the situation.

8. When the operation of the aircraft is unstable, attention should be paid to checking whether the clearance between the couplings is too tight and adjusting it in a timely manner.

Maintenance and upkeep:

Regular inspection: Regularly check the electrical circuits, bearing lubrication, tool sharpness, etc. of the equipment.

Cleaning and maintenance: Regularly clean the surface and interior of the equipment to prevent dust and impurities from accumulating and affecting its performance.

Replace worn parts: Timely replace worn parts such as screws, machine heads, cutting tools, etc. to ensure the normal operation of the equipment.