How much does it cost to supply a load tester

Two channel load testerMainly to meet the compressive strength testing requirements of users for cement and concrete products that can be tested for both large and small ranges. The mechanical performance tests of upper and lower water pipes, pipe piles, and various rigid and non rigid materials shall comply with GB/T16752- "Test Methods for Concrete and Reinforced Concrete Drainage Pipes". The instrument testing shall meet the accuracy requirements and comply with the testing and measurement of any provincial-level testing unit.

1. Purpose

Channel 1: Suitable for testing pressures up to 300KN;

Channel 2: Suitable for testing pressures up to 500KN;

2. Accuracy less than or equal to 1%

3. Force display unit: 0.01KN

4. AC power supply 220V 50Hz

5. Automatic zeroing

6. Operating environment temperature -5 ° C - --45 ° C

7. Use environmental humidity85%(Relative humidity)

Notes:

1The power supply voltage must be accurate and error free during use

2The cable connecting the sensor to the host must not have any intermediate joints. If it is damaged, the cable must be replaced and the wiring must be accurate.

3When using, it is necessary to follow the instructions and follow the prescribed procedures. In case of operational errors or display errors, please follow the instructionsPress the 'reset' button and then operate again.

4The instrument shall not be installed during the loading processPress the 'reset' button, otherwise the displayed force value is incorrect. After unloading, press the 'reset' button again in an unloaded state to reset the instrument to normal operation.

Two channel load testerThe channel can be switched at will. Different sensors can be used to test the piles with different bearing capacities, which will meet the accuracy requirements and factory requirements.