YSJ series injection molding machines use low noise three-phase asynchronous motors, Dongguan injection molding motors

Dongguan injection molding motor, YSJ series injection molding machine with low noise three-phase asynchronous motor product introduction:
YSJ series injection molding machines are equipped with low-noise three-phase asynchronous motors from Dongguan Motor FactoryA new series of products designed and developed based on the characteristics of plastic injection machinery, which not only has the Y series motor high efficiency, energy saving, good performance, low vibration, power level and installation size in accordance with IEC. In addition to its advantages of being standardized and easy to use and maintain, it also has strong overload capacity, low noise, especially at rated load and overload, which greatly reduces the noise of the entire machine and improves its performance. It is particularly suitable for injection molding machinery and occasions with strict noise requirements.

The performance indicators of this series of motors, such as efficiency, power factor, locked rotor torque, locked rotor current, maximum torque, etc., are the same as those of the Y series motors, and the noise is significantly reduced compared to the Y series motors. The motor has passed provincial appraisal and its noise level is at the leading level in China.

Injection motorUsage conditions:
1. The altitude shall not exceed 1000M.
2. Environmental temperature: -15~40 ℃.
3. Working mode: Continuous work system (S1).
4. The rated voltage is 380V, the rated frequency is 50HZ, the allowable variation range of the rated voltage is ± 5%, and the allowable variation range of the rated frequency is ± 1%.
5. Electric motors should be driven by couplings.
6. The protection level of the motor casing is IP44.
7. The cooling method for the electric motor is IC411.
operation mode:
Electric motors can operate continuously at rated load or periodically at 1.75 times rated load. The operating time at 1.75 times rated load should not exceed 20 seconds, and the operating cycle should not be less than 4 times the operating time at 1.75 times rated load.
Technical data: