Price of plastic handheld pump

Shanghai Chemical Handheld Pump

Hand held pumps, commonly known as bucket pumps, are mainly used to transport various acids, alkalis, solvents, additives, additives, oils, and other low to medium viscosity fluids in buckets or containers. More than 80% of applications. Pump tube lengths of 700mm, 1000mm, 1200mm, 1500mm, 1800mm, customized non-standard. Low viscosity pumps are suitable for transporting thin, neutral, corrosive, and highly flammable liquids. According to the properties of the liquid being transported, the pump tube material can be composed of aluminum alloy, stainless steel, 316 stainless steel, engineering plastics, etc. The drive motor is equipped with various options such as single-phase standard motor, explosion-proof motor, and high-speed motor.

Shanghai Chemical Handheld Pump

Before use, it is necessary to check whether each terminal is secure, and the grounding wire must be reliable and firm.

Check if the power supply voltage matches the rated voltage, and do not use it on power supplies that exceed or fall below 10% of the rated voltage.

Do not damage the wires and prevent water and oil from entering the motor, switch, electrical appliances, and other parts.

Ordinary electric models are prohibited from working under conditions containing flammable and corrosive gases to ensure safe production and the normal operation of various electrical components.

If any abnormal noise is found during use, the machine should be stopped immediately, the cause should be checked, and only after trying to eliminate it can it be continued to be used.

Stop the pump immediately after the liquid extraction is completed during use, as the motor of this series of pumps can reach a no-load speed of about 12000 revolutions per minute, otherwise it will be worn out, the universal joint impeller, and in severe cases, the pump tube may be damaged.

Replace the electric brush: When the electric brush is worn out and cannot be used, it should be replaced immediately, otherwise it will damage the commutator, and in severe cases, it is more likely to burn out the motor.

Regular inspections should be carried out, generally at least once every three months. For frequently used ones, they should be inspected once a month. The inspection should involve completely disassembling and eliminating internal dust and oil stains. If there is too much dust on the commutator, the surface of the commutator can be cleaned with alcohol. If there are damaged parts, they should be replaced with the same parts.

When not in use, please place it in a dry, clean, and non corrosive gas environment