PF125-1 butterfly leaf medium pressure blower 750W vortex air pump

PF125-1 butterfly leaf medium pressure blower 750W vortex air pumpIt belongs to a type of industrial cold air fan, with a large air volume and pressure during normal operationChineseIn terms of pressure range, the full air PF blower has a complete range of models and has a significant advantage in price compared to CX through type blowers. It is the * equipment for food manufacturing and workshop cooling!

PF125-1 butterfly leaf medium pressure blower 750W vortex air pumpUsage and installation:
1. The medium pressure fan should be placed in a relatively stable place, and the surrounding environment should be clean, dry, and well ventilated.
2. The rotation direction of the impeller of the medium pressure fan must be in the direction indicated by the arrow on the fan casing.
When the medium pressure fan is working, the working pressure should not exceed the high pressure value to avoid excessive heat generated by the fan and damage to the air pump caused by motor overcurrent.
4. Except for the two bearings of the motor rotor, there is no direct contact friction in other parts of the medium pressure fan. The installation method of bearings for this fan is mainly divided into two categories. *The bearing at the end of the class air pump is installed in the pump body between the motor base and the impeller, and this type of air pump does not need to be lubricated normally. The bearings on the second type of air pump end are installed in the middle of the pump cover, and the bearings on this type of air pump end should be regularly lubricated with grease (7018 high-speed grease). Once a month, for air pumps that work continuously in three shifts, the refueling frequency should be increased. The maintenance and upkeep of the bearings on the motor and fan end of this type of air pump shall be in accordance with the * type of air pump.
5. The filter screens and silencing devices at both ends of the medium pressure fan inlet and outlet should be cleaned in a timely manner according to the situation to avoid blockage and affect use.
6. Replacement of bearings for medium pressure fans: The replacement of bearings must be carried out by personnel familiar with repair work. First loosen the screws on the pump cover, and then disassemble the parts one by one according to the order shown in the diagram. The disassembled parts should be cleaned, and then assembled in reverse order. When disassembling, do not forcefully pry the impeller, use a roller to remove it, and do not miss the adjusting gasket to avoid affecting the clearance that has been adjusted before leaving the factory.
7. It is strictly prohibited for solids, liquids, and corrosive gases to enter the pump body of the medium pressure fan.