Supply cylinder quotation

NegotiableUpdate on 01/16

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

The Festo FESTO standard cylinder eliminates the weight of the crankshaft, allowing the engine to run at a relatively low idle speed. The idle speed of horizontally opposed engines is only about 580 revolutions per minute, which is not achievable with ordinary inline engines. The low idle speed of the engine naturally results in low fuel consumption.

Product Details

Festo FESTO standard cylinderBefore connecting the pipeline, it is necessary to clean the dirt inside the pipeline to prevent debris from entering the cylinder. The working temperature of the cylinder is usually set at 5-60 ℃. When cylinders are used in situations below 5 ℃, sometimes the condensation of moisture in compressed air can have adverse effects on cylinder operation. At this point, it is required that the dew point temperature of the compressed air be below 5 ℃ below the ambient temperature; Prevent condensation of water vapor in compressed air. At the same time, the type of seal and lubrication used at low temperatures should be considered.

1. A sturdy pull rod structure.
2. Dual action.
3. Electronic position sensing.
4. Can provide resistance to torsion.
5. EX4: Used in explosive hazardous areas.
6. The attachments are abundant, and the cylinder can be installed almost anywhere.

Festo FESTO standard cylinderMain parameters:

Position detection	Used for proximity sensors
Variants	Single ended piston rod
Work pressure	1 - 10 bar
Working mode	Double action
Working medium	Dry compressed air, lubricated or unlubricated
Corrosion resistance grade CRC	2
Environmental temperature	-20 - 80 °C
Impact energy at the terminal location	0,15 J
Buffer length	12 mm
Theoretical force at 6 bar, recovery stroke	103,7 N
Theoretical force at 6 bar, process	120,6 N
Moving mass at 0 mm stroke	23 g
Weight increase per 10 mm stroke	4,6 g
Basic weight at 0 mm stroke	89,9 g
Additional mass factor for every 10 mm stroke	2 g
Installation type	With attachments
Pneumatic connection	M5