Siemens temperature control valve supplier

Precautions for using Siemens temperature control valve

Siemens temperature control valve is affected by environmental humidity
The allowable environmental humidity for the n-actuator is ≤ 95% r. h, and there should be no moisture or dew
Beware of leakage and dripping of pipelines and equipment in the computer room

Siemens temperature control valve is affected by environmental humidity

The allowable environmental humidity for the n-actuator is ≤ 95% r. h, and there should be no moisture or dew

Beware of leakage and dripping of pipelines and equipment in the computer room

Pay attention to the secondary evaporation of condensed water

Maintain ventilation or scheduled air exchange and exhaust in the data center

Pay attention to rain protection for doors and windows, and prevent water leakage in buildings

Siemens temperature control valve is affected by ambient temperature

-The allowable ambient temperature for the actuator is ≤ 55 ℃;

-Pay attention to insulation of valve bodies, heat exchangers, and pipelines;

-Maintain ventilation or scheduled air exchange in the computer room;

-Avoid direct sunlight.

Siemens temperature control valve malfunction caused by outdoor installation

Ice formation: In winter, the outdoor temperature is low, and when the equipment is not in use, there is water stored inside, causing ice formation and expansion

UV irradiation: Plastic and electronic components are prone to aging

Rainwater: causing circuit boards to burn out and metal parts to rust

Dust: Accumulation of dirt on circuit boards and blockage of mechanical components

Precautions for installation position of Siemens temperature control valve

N should not be too high, otherwise it will be inconvenient for debugging, maintenance, and replacement

Avoid the upper pipeline of the regulating valve, especially the pipe flanges, joints and other fittings to prevent water leakage and damage to the actuator

The actuator should be installed on the upper part of the valve body to prevent water leakage and damage to the actuator

The installation of the valve body should not be installed at the bottom of the "U" shape of the pipeline or at the point where the equipment can condense water and flow backwards, in order to avoid water accumulation in the temperature control valve body, which may cause steam hammer during secondary steam flow

Siemens temperature control valve equipment starts up and runs

During the initial operation of the equipment, due to the significant temperature increase requirements of the heating pipe and secondary water, the temperature control valve will operate rapidly at full load, resulting in damage;

Suggest passing steam and water through the bypass, and then closing the bypass when the temperature on the secondary side reaches the set value (note that the bypass must be closed completely);

New pipeline network, the system has been in operation for a period of time, please be sure to clean the filter to avoid steam and water blockage and damage;

Pay attention to slow opening and fast closing of steam valves and slow opening and slow closing of water valves during operation

Maintenance and upkeep of Siemens temperature control valves

Regularly check and promptly troubleshoot the temperature control valve during operation

After the equipment is shut down, maintenance and repair should be carried out

Before starting up the equipment, perform maintenance and upkeep

When the equipment is not in use for a long time, pay attention to regular inspections, improve the environment of the computer room, and clean and protect parts that are prone to dust accumulation and rust

The operation and maintenance must be carried out by professional technicians who have undergone learning and training.