Quotation for electrostatic discharge simulator

NSG437 Electrostatic Discharge SimulatorBasic characteristics:

In order to implement a more reliable test, the 'high voltage power output self-test function'

Reduce installation errors by checking the CR value (no display)

Confirm the 'discharge check function' during air discharge

● More easily achieve long-term experiments! The lightest discharge gun in the industry (survey)

● Illuminate the 'LED light' of the EUT

The discharge box and CR components are also easy to replace (single key)

Adding discharge boxes and CR components can meet the ISO10605 standard:

In addition (optional), additional discharge boxes and CR components can be added to meet the ISO10605 standard. The replacement of the discharge box and CR components can be easily achieved, so one GT-30RA discharge gun can easily perform multiple CR value tests.

LCD panel with excellent recognition:

Redesign the previous operability to make it easier to use and operate. The test levels on the IEC standard are stored on the IEC Standard, so simply selecting the test level allows for easy setting. On MANUAL, voltage and test times can be set, and the setting conditions can be remembered. Also, it can be set in scanning mode. SEQUENCE can be combined by reading the conditions set in MANUAL. In addition, there are various functions such as built-in gun trigger settings and power dissipation device settings.

NSG437 Electrostatic Discharge SimulatorTechnical specifications:

IEC61000-4-2 Ed.2 Test Standard Introduction:

The IEC61000-4-2 standard is a standard for evaluating the immunity of electronic products to electrostatic discharge directly generated by the operator or from nearby objects in a relatively low humidity environment using chemical fiber balls, fabrics, etc. This standard simulates the phenomenon of a charged human holding metal and discharging it into electronic products, and specifies various procedures for conducting tests using circuits that can simulate the current waveform generated at this time. Desktop equipment test setup example (laboratory test) Direct discharge test is a test in which the test object is directly discharged and the reaction of the test object is observed. Place a 0.8m wooden table on the grounding plane, and place a horizontal coupling plate (1.6m * 0.8m) on the wooden table. The horizontal coupling plate is connected to the ground plane with two grounding wires of 470K Ω resistors. Lay an insulating film between the horizontal coupling plate and the measured object. Indirect discharge test is to discharge onto a horizontal coupling plate and a vertical coupling plate, and observe the reaction of the measured object. On the basis of the direct discharge test environment, a vertical coupling plate (0.5m * 0.5m) is used, which is also connected to the ground plane with two grounding wires of 470K Ω resistors.