Price of comprehensive testing system for computer version AC/DC charging gun

Introduction:

This device is suitable for full function inspection of national standard, European standard, and American standard AC charging guns, including a computer version console.

Details:

1、 Product Overview

This test bench complies with the requirements of GB/T 20234.2-2015, mainly for the full functional inspection of national, European, and American standard communication guns. Each gun can enter an independent QR code, and the test results are automatically saved to the report. If the test results are qualified, they will be automatically saved to the report. All functions are automatically tested in one go, with high efficiency and labor-saving, suitable for factory batch full inspection.

IIComputer version of comprehensive testing system for AC/DC charging gunDetection function

Testing of wire breakage, conductivity, short circuit, and misalignment of wire sequence for each wire

Resistance testing of RC and R4 in the circuit (including two states of button switch pressed and not pressed)

Inter line insulation test

Inter line voltage withstand test

Including: detecting AC three-phase charging guns (L1, L2, L3, N, E), AC single-phase charging guns (L

E、 ）Insulation and voltage resistance between wires

IIComputer version of comprehensive testing system for AC/DC charging gunMain parameters

Whole machine power input: single-phase AC 220V/50HZ 1KW

Gas source input: 0.6MPa

Control system: PLC+industrial computer

Computers can connect to the Mes system

The scanning gun is input into the computer, and the device is equipped with two scanning gun codes, which can scan the barcode on the test sample. Before testing, scan the barcode or QR code on the product and start the test with one click. After the test is completed, the scanned barcode can be associated with the test record, and subsequent test data can be traced through the corresponding barcode.

Equipped with a printer: report the test results after the test is completed.

The testing of wire breakage, conductivity, short circuit, and line sequence misalignment is carried out using PLC input and output for scanning and detection, and an alarm is triggered when there are errors.

Built in resistance test range: 50~5000 ohms, accuracy 1%

When measuring resistance, the button is automatically pressed by a cylinder, eliminating the need for manual pressing, saving labor and time, and achieving high automation

Inter line insulation test:

Insulation impedance parameters:

Insulation voltage: DC100-1000V can be set arbitrarily;

Lower limit setting: 1M~10G Ω can be set arbitrarily;

Accuracy: ± 5%;

Alarm insulation resistance value can be set: When the resistance value is less than the set value, it is defective;

Test time: 1~999.9s, standard 5s

Standard value: Insulation value>1000M Ω at 1000V

Inter line voltage withstand test:

Voltage endurance test parameters:

Voltage withstand: AC 0-5kV can be set arbitrarily;

Leakage current upper limit: AC 0.1mA~20mA can be set arbitrarily

Accuracy: ± 1.5%+3 words

Display mode: The digital display head indicates the current voltage

Test time: 1~999.9s, standard 5s

Standard value: Test time of 5 seconds at AC 2500V

Alarm detection: Defective when the leakage current value is greater than the set value;

Testing station: 1 station.

Both the head and tail are tested for different products by replacing the dedicated socket fixture of the universal testing station

When using a single gun head product, the tail plate adopts a special fixture to clamp the wire tail.

Socket height: The basic height of the socket is about 1000mm, which conforms to ergonomics:

Dimensions: W1100mmxD1000m × H1700mm, with movable casters with locking function at the bottom:

Weight: Approximately 300kg: