Integrated CS-3F Reverse Speed Sensor in Stock

NegotiableUpdate on 03/01

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

The CS-3F anti rotation speed sensor is equipped with permanent magnet steel. When there are rotating magnetic gears, perforated (or slotted) disks (or shafts) near the magnetic core end face, due to the change in magnetic resistance in the magnetic circuit, the inner coil of the sensor can induce and output a corresponding AC voltage signal, which is approximately a sine wave. The SZMB-12 magneto electric speed sensor has the advantages of no power supply, large output signal, good anti-interference performance, small size, sturdy and reliable, long service life, etc. It can be used in harsh environments such as smoke, water vapor, oil and gas. The SZMB-12 magneto electric speed sensor is commonly used to measure speed, cycle, and velocity. Widely used in machinery

Product Details

CS-3F Reverse Speed Sensor

The rotation of gears made of steel materials (or other magnetic materials) generates changes in magnetic flux, which can be measured by obtaining signals through sensitive components. The built-in circuit of the sensor amplifies and shapes the signal, outputting a stable square wave signal with a wider measurement frequency range and more accurate and stable output signal, enabling long-distance transmission. Easy to install, waterproof and oil resistant, with strong seismic performance.
Technical parameters
1. Working voltage: 5-24V
2. Measurement range: 0-20KHz
3. Speed measuring gear form: module 2-4 (involute gear)
4. Output signal: Square wave, whose peak to peak value is equal to the amplitude of the working power supply voltage, independent of the speed, with a maximum output current of 20mA
5. Working temperature: -30 to+130 ℃
6. Thread specification: Φ 16 sensor (installation thread: M16 × 1)
7. Installation gap: 1-5mm

Selection code: CS-2/CS-3-A □□ - B □□□ - C □□ Selection instructions:

Sensor length selection (L): A □□□ (Fill in the sensor length directly, in millimeters, default is 80mm)

Cable length selection: B □□ (directly fill in the cable length in meters, default is 2m)

Connection method selection: C □□

00: Plug connection method

* 01: Direct connection method

CS-3F Reverse Speed Sensor

The CS-3F gear reverse speed sensor is used to detect the forward and reverse rotation, speed, and linear velocity of the axle, gear, and rack. The acceleration of the measured object can also be obtained through calculation and processing. This sensor has good low-frequency and high-frequency characteristics. Low frequency can reach 0Hz and can be used for zero speed measurement of rotating machinery. As the sensor can provide two speed signals with a certain phase difference, it can be used for forward and reverse discrimination; The high frequency can reach up to 20KHz, which can meet the high-speed measurement requirements in most fields.

Electrical indicators:

Working voltage:

5 to 24V

Measurement range:

0到20KHz

² Output signal:

Square wave, whose peak to peak value is equal to the amplitude of the working power supply voltage, independent of the speed, with a large output current of 20mA