DKLFA30110-2RS-XL, INA bearings from Germany, one-stop shop for Anan Mall

Regarding the product:

(1) The product range of INA thrust angular contact ball bearings is very wide

Bearing arrangement that can meet the high dynamic operating conditions of screw driveDesign requirements include high precision, high load-bearing capacity, high stiffness, low friction, easy installation, and maintenance free or minimal maintenance. Through thisBy considering comprehensive and ideal products, specific solutions can be obtained to meet the technical and practical requirements of bearing arrangement in screw driveEconomic requirements.

(2) Single column and multi column design

There are several types of thrust angular contact ball bearings, including single row, double row, and triple row, all of which are ready to use units. They are inseparable and contain geometric rulersStable thick walled outer ring, ball bearings, cage components, and one or two inner rings. In some series, there are through holes on the outer ring flangeCan be installed on adjacent structures. These bearings have inner and outer rings that match each other, so when using precision locking nuts to lock the bearing rings, the bearingsIt can achieve pre tightening setting.

(3) Radial and axial load-bearing capacity

Due to its 60 ° contact angle, the bearing can withstand not only radial forces but also high axial forces.Double row, bolt mounted thrust angular contact ball bearings ZKLF are directly installed in adjacent structures or radial positioning holes through bolts. As a resultIt can eliminate the need for additional bearing end caps and related matching work.In order to facilitate the removal of the bearing from the positioning hole, a disassembly groove is designed on the outer circumference of the bearing. Equipped with detachable flat head screwsThe radial and axial threads make re lubrication work easier.

Adjacent structural design Adjacent structural design Configuration of fixed ball bearings supported by screw rods on both sides. The number of turns turned represents the position of the fixing bolt recommended by INA (see table or 'components' below).		d 30 mm Tolerance: -0010 D 75 mm Tolerance: -0013 B 56 mm Tolerance: -0,25 A 85 mm B1 35 mm D1 110 mm d1 51 mm d2 8,8 mm da max 64 mm da min 47 mm J 95 mm r1 min 0,6 mm rmin 0,3 mm be careful! The bearing must withstand continuous loads in the main load-bearing direction H. Heavy Duty Series m 2,5 kg quality Ca 59000 N Basic rated dynamic load, axial,